–  5 GHz, gain 5 dBi, internal omni, horizontal beamwidth 360°

–  1 x 10/100/1000BASE-T autosensing (RJ-45), AUX (used for Link Aggregation)

–  Management console port (RJ-45)

–  USB 2.0 (enabled via future software)

–  Nonoperating (storage) altitude test: 25˚C, 15,000 ft.

–  Operating temperature: -4° to 122°F (-20° to 50°C)

–  Operating humidity: 10% to 90% (noncondensing)

–  Operating altitude test: 40˚C, 9843 ft.

–  256 MB flash

–  Enhanced PoE

–  Cisco power injector, AIR-PWRINJ4=

–  Cisco local power supply, AIR-PWR-C=

–  Cisco power injector, AIR-PWRINJ5= (Note: this injector supports 802.3af only)

–  802.3af

Note: If 802.3af PoE is the source of power, (1) the 1852e 2.4-GHz radio will shift to 2×3 from 3×4, (2) The USB port and AUX Ethernet port are disabled on both the 1852i and 1852e.

Note: When deployed using a Power over Ethernet (PoE) specification, the power drawn from the power sourcing equipment will be higher by some amount, depending on the length of the interconnecting cable.

–  Physical security kit: AIR-SEC-50= (sold separately), with 50 pcs. security screws used to secure the access point onto wall-mounting bracket, 50 pcs. RJ-45 caps and 2 pcs. unlock keys used to block physical access to Ethernet ports

–  Radio approvals: FCC Part 15.247, 15.407, RSS-247 (Canada), EN 300.328, EN 301.893 (Europe), ARIB-STD 66 (Japan), ARIB-STD T71 (Japan), EMI and susceptibility (Class B), FCC Part 15.107 and 15.109, ICES-003 (Canada), VCCI (Japan), EN 301.489-1 and -17 (Europe), EN 50385

–  IEEE standards: IEEE 802.11a/b/g, 802.11n, 802.11h, 802.11d, IEEE 802.11ac

–  Security: 802.11i, WPA2, WPA, 802.1X, AES

–  Extensible Authentication Protocol (EAP) types: EAP-Transport Layer Security (TLS), EAP-Tunneled TLS (TTLS) or Microsoft Challenge Handshake Authentication Protocol Version 2 (MSCHAPv2), Protected EAP (PEAP) v0 or EAP-MSCHAPv2, EAP-Flexible Authentication via Secure Tunneling (FAST), PEAP v1 or EAP-Generic Token Card (GTC), EAP-Subscriber Identity Module (SIM)

–  Multimedia: Wi-Fi Multimedia (WMM)

–  Other: FCC Bulletin OET-65C, RSS-102

–  8.1 MR1 or later for the Cisco Aironet 1850 Series Access Points

–  Cisco Mobility Express

–  Maximal ratio combining (MRC)

–  20- and 40-MHz channels

–  PHY data rates up to 600 Mbps (40 MHz with 5 GHz)

–  Packet aggregation: A-MPDU (Tx/Rx), A-MSDU (Tx/Rx)

–  802.11 dynamic frequency selection (DFS)

–  Cyclic shift diversity (CSD) support

–  4×4 MIMO with three spatial streams, multiuser MIMO

–  MRC

–  802.11ac beamforming (transmit beamforming)

–  20-, 40-, and 80-MHz channels

–  PHY data rates up to 1.7 Gbps (80 MHz in 5 GHz)

–  Packet aggregation: A-MPDU (Tx/Rx), A-MSDU (Tx/Rx)

–  802.11 DFS

–  CSD support

–  Rogue device detection